BLRKR - DME MOLD SAVER
- MSDS: BLRKR
- Manufacturer: E F HOUGHTON AND CO
- Product Name: DME MOLD SAVER
- National Stock Number: 6810-00N020025
Product Identification
Product ID:DME MOLD SAVER
MSDS Date:06/27/1990
FSC:6810
NIIN:00N020025
MSDS Number: BLRKR
Responsible Party
US
Emergency Phone: 215-666-4105
Info Phone: 215-666-4105
Cage: 73227
Contractor
Telephone: 610-666-4105
Cage: 73277
Ingredients
LANOLIN
CAS: 8006-54-0
Fraction By Weight: 1-10%
ACETIC ACID ETHENYL ESTER POLYMER WITH ETHENE; (ACETATE
CAS: 24937-78-8
Fraction By Weight: 1-10%
FATTY ACID ESTER; (PARTIAL FATTY ESTER)
CAS: 61791-48-8
Fraction By Weight: 1-10%
XYLENES (O-,M-,P- ISOMERS) (SARA III)
CAS: 1330-20-7
RTECS: ZE2100000
Fraction By Weight: >60%
OSHA PEL 100 PPM/150 STEL
ACGIH TLV: 100 PPM/150STEL;9192
EPA Report Quantity: 1000 LBS
DOT Report Quantity: 1000 LBS
PARAFFIN WAX
CAS: 8002-74-2
RTECS: RV0350000
Fraction By Weight: 1-10%
OSHA PEL 2 MG/M3 (FUME)
ACGIH TLV: 2 MG/M3 (FUME); 9192
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE:INHAL:AVOID BREATHING PRODUCT
VAPORS. BREATHING VAPORS IN EXCESS OF THE TLV MAY CAUSE HEADACHE,
DIZZINESS OR NAUSEA. SKIN:MILD IRRITANT; MAY HAVE DEFATTING EFFECT.
EYE:MODERATE IRRITANT. INGEST: AVOID INGESTION; CAN CAUSE LIVER
DAMAGEIF ABSORBED INTO DIGESTIVE TRACT.
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:PERSONS W/CHRONIC RESPIRATORY
DISEASE MAY SHOW INCREASED SYMPTOMS DUE TO IRRITATION.
First Aid
First Aid:INHAL:REMOVE TO SOURCE OF FRESH AIR. SKIN: WASH W/SOAP &
WATER. APPLY SKIN CREAMS. EYE:FLUSH W/WATER FOR AT LEAST 15 MINS.
CONSULT MD. INGEST:DO NOT INDUCE VOMITING. USE VEGETABLE OIL
DEMULCENTS. CONS ULT MD. PRODUCT IS MAINLY XYLENE SOLVENT.
Fire Fighting
Flash Point Method:PMCC
Flash Point:80.0F,26.7C
Extinguishing Media:CARBON DIOXIDE, FOAM OR DRY CHEMICAL.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:VAPOR ACCUMULATION MAY FLASH &/OR EXPLODE
IF IGNITED.
Accidental Release
Spill Release Procedures:REMOVE ALL SOURCES OF SPK OR FLAME. APPLY DRY
ABSORB MATL & SWEEP UP. PROVIDE ADEQ VENT. MATL IS NOT CONSIDERED A
POLLUTANT IF EFTIVE WASTE DISP METH ARE UTILIZED. MATL IS NOT
SIGNIFICANTLY BIODEGRADA BLE; WATER INSOLUBLE. KEEP OUT OF
SEWERS/STREAMS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:KEEP AWAY FROM SOURCES OF EXCESSIVE
HEAT, SPARKS, OPEN FLAMES AND ETC. AVOID CONTACT W/STRONG
OXIDIZERS. USE WITH EFFECTIVE VENTILATION.
Other Precautions:NONE SPECIFIED BY MANUFACTURER.
Exposure Controls
Respiratory Protection:REQUIRED ONLY IF TLV IS EXCEEDED. NIOSH/MSHA
APPROVED RESPIRATOR APPROPRIATE FOR EXPOSURE OF CONCERN .
Ventilation:EXHAUST TYPE IS PREFERRED, ESPECIALLY IN CONFINED AREAS.
Protective Gloves:IMPERVIOUS GLOVES.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:NOT NEEDED.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.
Chemical Properties
HCC:F4
Boiling Pt:B.P. Text:280F,138C
Vapor Pres:6
Vapor Density:3.66
Spec Gravity:0.875
Evaporation Rate & Reference:0.8 (BUTYL ACETATE=1)
Solubility in Water:NEGLIGIBLE
Appearance and Odor:HAZY, LIGHT YELLOW LIQUID; ODOR OF XYLENE SOLVENT.
Percent Volatiles by Volume:88
Stability
Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZERS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:THERMAL; OXIDES OF CARBON.
Disposal
Waste Disposal Methods:FOLLOW REGS FOR DISP OF WASTE PETRO SOLV. THE
FLASH POINT OF THE PROD IS BELOW THE 140F LIMIT SET BY PRESENT RCRA
REGS, WHICH CLASSIFIES MATL AS A HAZARDOUS WASTE WHEN DISCARDED.
DISPOSAL MUST BE IN A CCORDANCE W/FEDERAL, STATE & LOCAL REGS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.